The jacket blowing machine is a little hot.
Contact
Product code : GT-TPA
Views : 5
CONTACT IN HANOI
Hotline : 0961230808 exit 1
Email : giangthanh@maymaygiangthanh.com
CONTACT IN HCM
Hotline : 0961230808 exit 3
Email : hcm@maymaygiangthanh.com
The hot air jacket blowing machine GT-TPA helps to increase the efficiency of jacket production by 200% to 300%.
- Model : GT-TPA
- Size: 1100mmx900mmx1600mm
- 3-phase 380v-50/60hz blowing motor, using variable frequency drive to control blowing speed with 4 levels (with speed setting)
- Maximum jacket pushing height: 1200mm
- Minimum jacket pushing height: 700mm
- Product clamping system: static (with adjustable shift)
+ Smallest static product clamping: 270mm
+ Largest static product clamping: 310mm
+ Smallest dynamic product clamping: 270mm
+ Largest dynamic product clamping: 670mm
- Uses 16mm cylinder for product clamping jaws
+ 16x150 cylinder for retraction stroke for dead product clamping
+ 16x200 cylinder for pushing stroke for jacket stretching
- Uses belt motor for product lifting
- The machine has 3 running modes
+ Automatic: fully automatic operation by setting parameters
+ Semi-automatic: foot pedal control for each jacket clamping cycle
+ Automatic jacket lifting and semi-automatic jacket clamping (combination of semi-automatic and automatic)
- Uses hot air provided by the factory through the machine's hot air separation and filtration system to work
- Can set the hot air pre-heat mode before blowing and stretching the jacket, or set the hot air pre-heat time along with the jacket stretching time, or turn off hot air and use only cold air